KN-300T is silicone adhesive which is used for cured silicone rubber bonding PVC, PC, metal, nylon or ABS
The Silicone rubber is damaged
when break off the bonding units
Glue amount drops to 75% , Bonding effect 30% higher
No Whity ,No getting hardened
after the KN-300X cured
Withstand water boiling tests
Good Sealing function
Once KN-300X is cured , it's silicone elasticity
which is electrical insulation,vibration absorbant.
Appearance : Colorless and semi-transparent paste
|Elongation : 200%|
|Hardness : 30A|
1,Cleaning material surface for bonding. Metal surface is cleaned by toluene. Plastic is cleaned by absolute ethyl alcohol 2,Coating adhesive thickness≤1mm
3,At least 30 minutes pressing, the adhesive is cured completely after 24 hours at room temperature.
1,Need to clean surface for bonding,avoid the greasy dirt.
2,Make sure uniform pressure to keep bonded parts together
3,KN-300T is easy to cure once contacting with moisture, it must be stored in a completely sealed packaging and away from the away from light and hot.
4,Avoid eye contact adhesive,If contact ,rinse with water immediately ,then go to see the doctor.
5,Please fasten down the the caps after using to avoid the gel to be cured.