Bonding silicone rubber to PC,RTV Silicone Rubber glue cures in room temperature without heating, The adhesive features with good bond for silicone rubber to PC , waterproof , high temperature tolerance .food and medical application , no white , soft rub
|Tel: +0086-180 9899 4276|
KN-300H is silicone adhesive which is used for the cured silicone bonding with metal, glass, ceramic tile, plastic, alloy or other materials. KN-300B is high and low temperature resistance(-60~200℃), weather resistance, excellent bonding, fixation, sealing, insulation, moistureproof, shakeproof, ageing resistant etc.
The Silicone rubber is damaged
when break off the bonding units
Glue amount drops to 75% , Bonding effect 30% higher
No Whity ,No getting hardened
after the KN-300X cured
Withstand water boiling tests
Good Sealing function
Once KN-300X is cured , it's silicone elasticity
which is electrical insulation,vibration absorbant.
Appearance: Black paste
Viscosity: 120000 mPa.S
1, Cleaning material surface for bonding. Metal surface is defatted treatment clean. Plastic is cleaned by absolute ethyl alcohol. 2, Coating adhesive thickness≤1mm
3, At least 30 minutes pressing, the adhesive is cured completely after 24 hours at room temperature.
1, According to use quantity, extrusion adhesive can be used, cutting out the shell cover of nozzle head, install a dedicated syringe (Pneumatic gun or manual gun). Please fasten down the the caps after using to avoid the gel to be cured.
2, The adhesive complete curing time is according to air contact area and the thickness, more thin coating adhesive, the curing time is more short. Appropriately raise the environmental temperature (shall not exceed 60℃) and humidity can reduce curing time.
3, Avoid eye contact adhesive, If contact, rinse with water immediately, then go to see the doctor.