Tel: +86.755.8147.8876 | ||
Fax: +86.755.8147.8872 | ||
E-mail: sales@bondsil.com |
Good adhesion Strength
No partial bonding failure
No primer trace on finished silicone products
Waterproof Function
4 Hours water- boiling Tests Stable Quality
3 times repetitive standard tests
Making your silicone products 99% ok rates
Appearance:Transparent or Pasty gel
Ratio:A:B=1:1
Solvent:Component solvent
Viscosity: <20mpa.s
Specifical gravity: 0.95 g/cm3
Shelf life:6 months without cover opened(25℃).
1,Coating the CL-26AB-8 on the edge of the glass.
2,Direct the LSR silicone on the edge the glass in the injection moulding machine ,
apply 120~180℃ degrees for 1-3 minutes to vulcanize the silicone rubber .
3,Trim the rough edges and wash clean the glass covers
4, Place the glass covers in the ovens, apply 180~220℃ for 1- 2 hours , a silicone glass cover is done made .
1, Please cap its cover immediately after use to avoid volatilization.
2, Store the used and unused adhesive in separate way to lengthen the shelf life.
3, After the primer coated on the substrates, leave it volatilize completely before entering the mold, otherwise, there will be bubbles in the
finished products
4, Wash clean the substrates to remove dirts or oil to avoid bad adhesion.
TDS: CL-26AB-8
SGS : CL-26AB-8.PDF