FAQ
Contact us
Email: sales@bondsil.com
Tel:
Addr: H Building ,Xinwei The 3rd Industrial Park,Dalang Street,Longhua New District , Shenzhen City ,Guangdong Province ,China
Kanglibang High Temperature Silicone Bonding Machine for Sealing O Ring Gasket
23 Feb 2023
For recent silicone market, more and more factories choose the bonding machine for making silicone sealing O rings, tubes etc. It will be a high efficiency method to improve the production.
High Temperature Bonding Machine
I- Layout of structure
Main Properties:
1, Automatic temperature control, time control, easy to use.
2, Fast working efficiency, stably operation system, positioning accuracy, low noise.
3, Mainly used for bonding silicone tubes, special pipe, circular tube etc.
4, International standard electrical apparatus element
II- Technique Data Support:
Up die working area: 100mm
The Fast working frequency:1000 times/hour
Working Air Pressure: 4-6bar
Power Input: AC220V
50Hz
III- Safety Information and Routine Maintenance
Safety information:
1: Please read carefully the manuals before operating the machine, and new operators
must pass job training tests.
2: Please check the power plug and air plug and confirm both have been connected
correctly. Make sure that the earth wire is connected reliably with the device’s body, and
check all components that have been installed firmly.
3: In the operation, operating the same machine at the same time by two or more people
is banned.
4: In the event of abnormal operation should immediately turn off the air supply firstly,
then shutting down power switch. After that, the professional must check and treat the
machine.
IV- Routine Maintenance:
To extend service life, please maintain the equipments and confirm that they are in good
condition, mainly depending on the following rules:
1: Environment: keep the working environment clean, without dust
2: Power: stable power supply, if not, voltage stabilizer will be necessarily installed on the
machine.3: Air supply: Keep the compressed air clean, without any dust, and let out the polluted
water from the filtering cup regularly.
4: Keep the equipments clean, and confirm the moving part without dust interference. If
not using the machine for a long time, please coat rust-proof oils on the adjusting screw
rod, pack it well and arrange it properly.
5: Add the lubricating oil on the moving part of the equipment.
6: Before bonding tubes, please check the pressure and temperature of upper and lower
copper-formed mould, and ensure its bonding groove clean.
