Home > FAQ

FAQ
Contact us

Email: sales@bondsil.com

Tel:+86.755.8147.8876

Addr: H Building ,Xinwei The 3rd Industrial Park,Dalang Street,Longhua New District , Shenzhen City ,Guangdong Province ,China

After forming the silicon film to metal at room temperature bonding what method?

02 Sep 2019 - Quick-drying type

After molding, there are two ways to bond silicon film and metal at room temperature:

1. Quick-drying type: clean the bonding surfaces of silica gel and metal to be dried with toluene or acetone (usually less than 1 minute to remove oil stains);Spray, brush and place the silicone surface for 5 minutes with the silicone primer cl-16 again (to activate the silicone surface);Apply a small amount of quick-drying glue 601 or 603 to the surface of silicone or metal to be bonded;Finally, press the two together for 5 to 10 seconds.

Quick-drying type

2. Slow drying: clean the bonding surfaces of silica gel and metal to be dried with toluene or acetone (usually less than 1 minute to remove oil stains);Once again, evenly brush kn-300a on the interface of silica gel or metal to be bonded;Then fit the two together and hold or press them (as long as they are not displaced) for 8 hours.

Slow drying

KANGLIBANG is to creat solution for your problem with bonding silicone, welcome customer inquiry to us.

contact us

Mobile:

+0086-135 0281 9396 Edsion YIN (Sales)

+0086-18098994276 Gary Lee (Sales)

+0086-13823747978 Coco Wei (Sales)

Fax:

+86.755.8147.8872

Address:

H Building ,Xinwei The 3rd Industrial Park,Dalang Street,Longhua New District , Shenzhen City ,Guangdong Province ,China

Message

Technical support:baiila